Standard
Active
Last Updated: Nov 27, 2024
Track Document
ASTM D5007-99(2024)
Standard Test Method for Wet-to-Dry Hiding Change
Standard Test Method for Wet-to-Dry Hiding Change
D5007-99R24
ASTM|D5007-99R24|en-US
Standard Test Method for Wet-to-Dry Hiding Change
Standard
D5007 Standard Test Method for Wet-to-Dry Hiding Change>
new
BOS Vol. 06.02 Committee D01
$
72.00
In stock
ASTM International
Significance and Use
5.1 Many architectural paints, particularly white and light tints, change significantly in film opacity as they dry. An increase in hiding is sometimes associated with porosity and poor film integrity with conventionally formulated coatings. A decrease can result in a disappointing paint job. The wet-to-dry hiding change is therefore a property of great practical importance.
5.2 This test method can be used in paint specifications and as a short, simple procedure for evaluation and quality control.
Scope
1.1 This test method covers the determination of the change in hiding power of an architectural coating during drying, by visual evaluation of the wet and dry film.
1.2 This test method is not recommended for colors other than white and tints.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.