Standard
Historical
Last Updated: Jun 30, 2015
Track Document
ASTM D4889-04(2011)
Standard Test Methods for Polyurethane Raw Materials: Determination of Viscosity of Crude or Modified Isocyanates
Standard Test Methods for Polyurethane Raw Materials: Determination of Viscosity of Crude or Modified Isocyanates
D4889-04R11
ASTM|D4889-04R11|en-US
Standard Test Methods for Polyurethane Raw Materials: Determination of Viscosity of Crude or Modified Isocyanates
Standard
D4889 Standard Test Methods for Polyurethane Raw Materials: Determination of Viscosity of Crude or Modified Isocyanates>
new
BOS Vol. 08.02 Committee D20
$
77.00
In stock
Significance and Use
These test methods can be used for research or for quality control to characterize isocyanates used in polyurethane products.
Viscosity measures the resistance of a fluid to uniform continuous flow without turbulence or other forces.
Some isocyanates exhibit non-Newtonian behavior under certain conditions. Whenever possible, generate results for comparison under the same conditions, that is, the same spindle/speed combination for Brookfield viscosity and the same tube size for Cannon-Fenske viscosity.
Scope
1.1 These test methods (A and B) determine the viscosity of crude or modified isocyanates. They are applicable to products derived from toluene diisocyanate, methylene-bis-(4-phenylisocyanate), and polymethylene polyphenylisocyanates (see Note 1).
Note 1—Test method A includes a procedure for measuring dynamic viscosity using a rotational Brookfield instrument. Test method B is simply a reference to a general procedure for measuring kinematic viscosity using a Cannon-Fenske instrument, D445.
1.2 The values stated in SI units are to be regarded as standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards statements see Warnings at the end of 5.1 and 10.5.
Note 2—There is no known ISO equivalent to this standard.