Standard
Active
Last Updated: May 17, 2023
Track Document
ASTM D4878-23
Standard Test Methods for Polyurethane Raw Materials: Determination of Viscosity of Polyols
Standard Test Methods for Polyurethane Raw Materials: Determination of Viscosity of Polyols
D4878-23
ASTM|D4878-23|en-US
Standard Test Methods for Polyurethane Raw Materials: Determination of Viscosity of Polyols
Standard
D4878 Standard Test Methods for Polyurethane Raw Materials: Determination of Viscosity of Polyols>
new
BOS Vol. 08.02 Committee D20
$
72.00
In stock
ASTM International
Significance and Use
4.1 These test methods are suitable for research or as quality control or specification tests.
4.2 Viscosity measures the resistance of a fluid to uniformly continuous flow without turbulence or other forces.
Scope
1.1 These test methods (A and B) determine the viscosity of polyols in the range from 10 to 100 000 mPa·s(cP) at 25°C. Test Method A is a rotational procedure for determining dynamic viscosity. Test Method B is a general procedure for kinematic viscosity of transparent polyols. (See Note 1.)
1.2 The values stated in SI units are to be regarded as the standard. Other equivalent units are provided because of current common usage.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 1: Test Method A is equivalent to ISO 3219. Test Method B is equivalent to ISO 3104.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.