Standard Classification System for Acrylonitrile-Butadiene-Styrene (ABS) Plastics and Alloys Molding and Extrusion Materials

1.1 This classification system covers only ABS materials and ABS alloys suitable for injection molding and extrusion. Some of these compositions may also be suitable for compression molding. Recycle ABS and alloys will be addressed in a separate standard.

1.2 This classification system is not intended for the selection of materials, but only as a means of calling out materials to be used in the manufacture of parts. Materials are to be selected by personnel with expertise in the plastics field where the economics, the environment to be encountered, the inherent properties of the materials, the part design, the part performance required, and the manufacturing process to be employed all enter into the selection.

1.3 The properties included in this classification system are those required to identify the compositions covered. There may be other requirements necessary to identify particular characteristics important to specialized applications. These will be agreed upon between the user and the supplier by using the suffixes given in Section 5.

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 The following precautionary caveat pertains only to the test methods portion, Section 12, of this classification system: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—This classification system and ISO 2580 are technically equivalent for those tests contained in both standards.