Standard
Historical
Last Updated: Dec 05, 2025
Track Document
ASTM D4572-21
Standard Test Method for Rubber Chemicals—Wet Sieve Analysis of Sulfur
Standard Test Method for Rubber Chemicals—Wet Sieve Analysis of Sulfur
D4572-21
ASTM|D4572-21|en-US
Standard Test Method for Rubber Chemicals—Wet Sieve Analysis of Sulfur
Standard
D4572 Standard Test Method for Rubber Chemicals—Wet Sieve Analysis of Sulfur>
new
BOS Vol. 09.01 Committee D11
$
64.00
In stock
ASTM International
Significance and Use
3.1 This test method is used to evaluate sulfur for suitability as a rubber vulcanizing agent. Sulfur particles must be significantly small enough to dissolve in rubber during cure and produce a uniform network of cross-links. This test method is used as a quality control method to ensure that no excessively large sulfur particles are present and to see if the product follows a typical pattern of size distribution.
3.2 This procedure is necessary when problems of the sulfur caking occur with the use of the dry sieving procedure for particle size.
Scope
1.1 This test method covers the evaluation of the particle size distribution of the coarse fraction of sulfur. It is limited to the measurement of those particles greater than 45 μm (No. 325 sieve).
1.2 Units—The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.