Standard
Active
Last Updated: Jan 10, 2020
Track Document
ASTM D4196-05(2019)
Standard Test Method for Confirming the Sterility of Membrane Filters
Standard Test Method for Confirming the Sterility of Membrane Filters
D4196-05R19
ASTM|D4196-05R19|en-US
Standard Test Method for Confirming the Sterility of Membrane Filters
Standard
D4196 Standard Test Method for Confirming the Sterility of Membrane Filters>
new
BOS Vol. 11.02 Committee D19
$
64.00
In stock
Significance and Use
5.1 This test method may be employed to check the sterility of commercially procured sterile membrane filters. The test also confirms that sterilized filters have not been contaminated. Additionally, this test may be used to monitor the efficacy of in-house sterilization procedures. Filter packages that have obvious packaging defects should not be tested because sterility may have been compromised.
Scope
1.1 This test method describes a test to confirm the sterility of either manufacturer presterilized or user-sterilized analytical membrane filters.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.