Standard
Historical
Last Updated: May 02, 2023
Track Document
ASTM D4082-10(2017)
Standard Test Method for Effects of Gamma Radiation on Coatings for Use in Nuclear Power Plants
Standard Test Method for Effects of Gamma Radiation on Coatings for Use in Nuclear Power Plants
D4082-10R17
ASTM|D4082-10R17|en-US
Standard Test Method for Effects of Gamma Radiation on Coatings for Use in Nuclear Power Plants
Standard
D4082 Standard Test Method for Effects of Gamma Radiation on Coatings for Use in Nuclear Power Plants>
new
BOS Vol. 06.02 Committee D33
$
77.00
In stock
Significance and Use
4.1 This test method is designed to provide a uniform test to assess the suitability of coatings, used in nuclear power facilities, under radiation exposure for the life of the facilities, including radiation during a DBA (Coating Service Level I areas only). Specific plant radiation exposure may exceed or be less than the amount specified in 7.2 of this standard. If required by the licensee design basis, the gamma dose used may exceed the actual anticipated plant gamma dose to account for beta dose. Coatings in Level II and III areas (outside primary containment) are expected to be exposed to lower accumulated radiation doses.
Scope
1.1 This test method covers a standard procedure for evaluating the lifetime radiation tolerance of coatings to be used in nuclear power plants. This test method is applicable to Coating Service Levels I, II, and III.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.