Standard
Active
Last Updated: Nov 22, 2022
Track Document
ASTM D3994-22
Standard Performance Specification for Woven Swimwear Fabrics
Standard Performance Specification for Woven Swimwear Fabrics
D3994-22
ASTM|D3994-22|en-US
Standard Performance Specification for Woven Swimwear Fabrics
Standard
D3994 Standard Performance Specification for Woven Swimwear Fabrics>
new
BOS Vol. 07.01 Committee D13
$
64.00
In stock
Significance and Use
5.1 Upon mutual agreement between the purchaser and the supplier, woven fabrics intended for this end use should meet all of the requirements listed in Table 1 of this specification.
5.2 It is recognized that for purposes of fashion or aesthetics the ultimate consumer of articles made from these fabrics may find acceptable fabrics that do not conform to all of the requirements in Table 1. Therefore, one or more of the requirements listed in Table 1 may be modified by mutual agreement between the purchaser and the supplier.
5.2.1 In such cases, any references to the specification shall specify that: “This fabric meets ASTM Specification D3994, except for the following characteristic(s).”
5.3 Where no prepurchase agreement has been reached between the purchaser and the supplier, and in case of controversy, the requirements listed in Table 1 are intended to be used as a guide only. As noted in 5.2, ultimate consumer demands dictate varying performance parameters for any particular style of fabric.
5.4 The significance and use of particular properties and test methods are discussed in the appropriate sections of the specified test methods.
Scope
1.1 This performance specification covers woven fabrics for use in men's, women's and children's swimwear, composed of any textile fiber or mixture of textile fibers.
1.2 These requirements apply to the length and width directions for those properties where fabric direction is pertinent.
1.3 The following safety hazards caveat pertains only to the test method described in this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.