Standard
Historical
Last Updated: Sep 15, 2025
Track Document
ASTM D3663-20
Standard Test Method for Surface Area of Catalysts and Catalyst Carriers
Standard Test Method for Surface Area of Catalysts and Catalyst Carriers
D3663-20
ASTM|D3663-20|en-US
Standard Test Method for Surface Area of Catalysts and Catalyst Carriers
Standard
D3663 Standard Test Method for Surface Area of Catalysts and Catalyst Carriers>
new
BOS Vol. 05.06 Committee D32
$
86.00
In stock
ASTM International
Abstract
This test method establishes the standard procedure for determining the surface areas of catalyst and catalyst carriers that have Type II or IV nitrogen adsorption isotherms, and specified minimum area. A volumetric measuring system is used to obtain at least four data points which fit on the linear BET line. The surface area of a catalyst or catalyst carrier is determined by measuring the volume of nitrogen gas adsorbed at various low-pressure levels by the catalyst sample. Pressure differentials caused by introducing the catalyst surface area to a fixed volume of nitrogen in the test apparatus are measured and used to calculate BET surface area.
Scope
1.1 This test method covers the determination of surface areas of catalyst and catalyst carriers that have Type II or IV nitrogen adsorption isotherms, and at least 1 m2/g of area. A volumetric measuring system is used to obtain at least four data points which fit on the linear BET2 equation line.
1.2 Units—The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.