Standard
Active
Last Updated: May 31, 2024
Track Document
ASTM D3588-98(2024)e1
Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels
Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels
D3588-98R24E01
ASTM|D3588-98R24E01|en-US
Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels
Standard
D3588 Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels>
new
BOS Vol. 05.06 Committee D03
$
72.00
In stock
ASTM International
Significance and Use
5.1 The heating value is a measure of the suitability of a pure gas or a gas mixture for use as a fuel; it indicates the amount of energy that can be obtained as heat by burning a unit of gas. For use as heating agents, the relative merits of gases from different sources and having different compositions can be compared readily on the basis of their heating values. Therefore, the heating value is used as a parameter for determining the price of gas in custody transfer. It is also an essential factor in calculating the efficiencies of energy conversion devices such as gas-fired turbines. The heating values of a gas depend not only upon the temperature and pressure, but also upon the degree of saturation with water vapor. However, some calorimetric methods for measuring heating values are based upon the gas being saturated with water at the specified conditions.
5.2 The relative density (specific gravity) of a gas quantifies the density of the gas as compared with that of air under the same conditions.
Scope
1.1 This practice covers procedures for calculating heating value, relative density, and compressibility factor at base conditions (14.696 psia and 60 °F (15.55 °C)) for natural gas mixtures from compositional analysis.2
1.2 This practice applies to all common types of utility gaseous fuels, for example, dry natural gas, reformed gas, oil gas (both high and low Btu), propane-air, carbureted water gas, coke oven gas, and retort coal gas, for which suitable methods of analysis as described in Section 6 are available. Calculation procedures for other base conditions are given.
1.3 Units—The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.