Standard
Active
Last Updated: Mar 29, 2017
Track Document
ASTM D3574-17
Standard Test Methods for Flexible Cellular Materials—Slab, Bonded, and Molded Urethane Foams
Standard Test Methods for Flexible Cellular Materials—Slab, Bonded, and Molded Urethane Foams
D3574-17
ASTM|D3574-17|en-US
Standard Test Methods for Flexible Cellular Materials—Slab, Bonded, and Molded Urethane Foams
Standard
D3574 Standard Test Methods for Flexible Cellular Materials—Slab, Bonded, and Molded Urethane Foams>
new
BOS Vol. 08.02 Committee D20
$
104.00
In stock
Significance and Use
5.1 The test procedures provide a standard method of obtaining data for research and development, quality control, acceptance and rejection under specifications, and special purposes.
5.2 The data obtained by these test methods are applicable to the material under conditions of the particular test and are not necessarily the same as obtained in other environments in use.
Scope
1.1 These test methods apply to slab, bonded, and molded flexible cellular products known as urethane foams. Urethane foam is generally defined as an expanded cellular product produced by the interaction of active hydrogen compounds, water, and isocyanates.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.3 The values stated in SI units are to be regarded as standard.
Note 1: There is no known ISO equivalent to this standard, however certain test methods in this standard have similar or equivalent ISO standards and are listed in the scope of the individual test method sections.