Standard
Active
Last Updated: Jan 09, 2024
Track Document
ASTM D3193-24
Standard Specification for Ethylbenzene
Standard Specification for Ethylbenzene
D3193-24
ASTM|D3193-24|en-US
Standard Specification for Ethylbenzene
Standard
D3193 Standard Specification for Ethylbenzene>
new
BOS Vol. 06.04 Committee D16
$
64.00
In stock
ASTM International
Abstract
This specification covers ethylbenzene. Different tests shall be conducted in order to determine the following properties of ethylbenzene: purity, benzene content, toluene content, xylene content, cumene content, diethylbenzene content, chloride content, sulfur content, and color.
Scope
1.1 This specification covers ethylbenzene.
1.2 The following applies to all specified limits in this specification for purposes of determining conformance with this specification, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.
1.3 The values stated in SI units are to be regarded as standard. No other units of measure are included in this specification.
1.4 Consult current OSHA regulations, supplier’s Safety Data Sheet for all materials, and local regulations used in this specification.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.