Standard
Historical
Last Updated: Apr 10, 2017
Track Document
ASTM D3042-09(2015)
Standard Test Method for Insoluble Residue in Carbonate Aggregates
Standard Test Method for Insoluble Residue in Carbonate Aggregates
D3042-09R15
ASTM|D3042-09R15|en-US
Standard Test Method for Insoluble Residue in Carbonate Aggregates
Standard
D3042 Standard Test Method for Insoluble Residue in Carbonate Aggregates>
new
BOS Vol. 04.03 Committee D04
$
77.00
In stock
Significance and Use
3.1 The amount and size distribution of noncarbonate (insoluble) material in carbonate aggregates is of interest to those conducting research on the polish susceptibility of stone used in pavements or on the friction properties of pavement surfaces. In addition, some agencies utilize the test for acceptance purposes to delineate carbonate aggregates that polish excessively and become slippery and those that will not.
Note 1: The quality of the results produced by this standard are dependent upon the competence of the personnel performing the procedure and the capability, calibration, and the maintenance of the equipment used. Agencies that meet the criteria of Practice D3666 are generally considered capable of competent and objective testing/sampling/inspection/etc. Users of this standard are cautioned that compliance with Practice D3666 alone does not completely assure reliable results. Reliable results depend on many factors: following the suggestions of Practice D3666 or similar acceptable guideline provides a means of evaluating and controlling some of those factors.
Scope
1.1 This test method covers determination of the percentage of insoluble residue in carbonate aggregates using hydrochloric acid solution to react the carbonates.
1.2 The values stated in SI units are to be regarded as standard. Regarding sieves, per Specification E11, “The values stated in SI units shall be considered standard for the dimensions of the wire cloth openings and the diameter of the wires used in the wire cloth. The values stated in inch-pound units shall be considered standard with regard to the sieve frames.” When sieve mesh sizes are referenced, the alternate inch-pound designations are provided for information purposes and enclosed in parentheses.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precaution statements are given in Section 7.