Standard
Historical
Last Updated: Apr 08, 2016
Track Document
ASTM D2911-10
Standard Specification for Dimensions and Tolerances for Plastic Bottles
Standard Specification for Dimensions and Tolerances for Plastic Bottles
D2911-10
ASTM|D2911-10|en-US
Standard Specification for Dimensions and Tolerances for Plastic Bottles
Standard
D2911 Standard Specification for Dimensions and Tolerances for Plastic Bottles>
new
BOS Vol. 08.01 Committee D20
$
96.00
In stock
Abstract
This specification covers the thread configuration and dimensions for finishes for plastic bottles with screw-type closures. The bottle overflow and body dimensional tolerances are detailed. The test apparatus for determining bottle capacity consists of a balance, pipet, graduated cylinder, beaker, conditioned water, and stop watch. In addition, the test apparatus for determining finish and body dimensions includes micrometers, Vernier height gages or Vernier calipers, internal micrometers or telescoping gages, and commercial scale. The test methods discussed are for the determination of bottle capacity, body dimensions, and finish dimensions.
Scope
1.1 This specification covers the thread configuration and dimensions for finishes for plastic bottles with screw-type closures, having a maximum capacity of 18.9 L (5 gal) and a maximum bottle dimension of 305 mm (12 in.). Included are tolerances for bottle capacity and body dimensions.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 The following precautionary caveat pertains only to the test methods portion, Section 8 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1—There is no known ISO equivalent to this standard.