Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM D2714-94(2003)
Standard Test Method for Calibration and Operation of the Falex Block-on-Ring Friction and Wear Testing Machine
Standard Test Method for Calibration and Operation of the Falex Block-on-Ring Friction and Wear Testing Machine
D2714-94R03
ASTM|D2714-94R03|en-US
Standard Test Method for Calibration and Operation of the Falex Block-on-Ring Friction and Wear Testing Machine
Standard
D2714 Standard Test Method for Calibration and Operation of the Falex Block-on-Ring Friction and Wear Testing Machine>
new
BOS Vol. 05.01 Committee D02
$
77.00
In stock
Significance and Use
This test method is used for the calibration of a block-on-ring testing machine by measuring the friction and wear properties of a calibration fluid under the prescribed test conditions.
The user of this test method should determine to his or her own satisfaction whether results of this test procedure correlate with field performance or other bench test machines. If the test conditions are changed, wear values can change and relative ratings of fluids can be different.
Scope
1.1 This test method covers the calibration and operation of a block-on-ring friction and wear testing machine.
1.2 The values stated in either SI (metric) units or inch-pound units to be regarded separately as standard. Within the text the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. Combining values of the two systems may result in noncomformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.