Standard
Historical
Last Updated: Apr 22, 2013
Track Document
ASTM D2595-96(2008)
Standard Test Method for Evaporation Loss of Lubricating Greases Over Wide-Temperature Range
Standard Test Method for Evaporation Loss of Lubricating Greases Over Wide-Temperature Range
D2595-96R08
ASTM|D2595-96R08|en-US
Standard Test Method for Evaporation Loss of Lubricating Greases Over Wide-Temperature Range
Standard
D2595 Standard Test Method for Evaporation Loss of Lubricating Greases Over Wide-Temperature Range>
new
BOS Vol. 05.01 Committee D02
$
77.00
In stock
Significance and Use
The loss of volatile materials from greases and oils can adversely affect the original performance characteristics of a lubricant and, therefore, could be a significant factor in evaluating a lubricant for a specific use. Such volatiles can also be considered contaminants in the environment in which the lubricant is to be used. Correlation between results from this test method and service performance has not been established.
The test method can be used at any specified temperature between 93 and 316°C (200 and 600°F) that may be agreed upon by the user of the method. (Warning—This test method should not be used at temperatures which exceed the flash point of the base oil of the grease.)
Note 1—The specified flow of air, 2.58 ± 0.02 g/min, (2 L/min at standard temperature and pressure), assumes dry air. It is not known that the original work involved dry air but it has since been shown that this can be a factor in reproducibility and should be addressed. Air with a dew point of less than 10°C at standard temperature and pressure will be satisfactory.
Scope
1.1 This test method covers the determination of evaporation loss of lubricating greases at temperatures between 93 and 316°C (200 and 600°F). This test method is intended to augment Test Method D 972
1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific safety information, see 5.2.