Standard
Historical
Last Updated: Nov 14, 2016
Track Document
ASTM D2370-98(2010)
Standard Test Method for Tensile Properties of Organic Coatings
Standard Test Method for Tensile Properties of Organic Coatings
D2370-98R10
ASTM|D2370-98R10|en-US
Standard Test Method for Tensile Properties of Organic Coatings
Standard
D2370 Standard Test Method for Tensile Properties of Organic Coatings>
new
BOS Vol. 06.01 Committee D01
$
77.00
In stock
Significance and Use
Tensile properties determined by this method are of value in studying the behavior of coatings subjected to environmental stresses, such as those produced by aging and weathering. (See Refs. (1-10).)
Tensile properties may vary with specimen thickness, method of preparation, gage length, rate of load application, tensile tester response, and type of grips used. Consequently, where precise comparative results are desired, these factors must be carefully controlled.
Scope
1.1 This test method covers the determination of the elongation, tensile strength, and stiffness (modulus of elasticity) of organic coatings when tested as free films.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 7.