Standard
Active
Last Updated: Feb 07, 2023
Track Document
ASTM D2203-01(2023)
Standard Test Method for Staining from Sealants
Standard Test Method for Staining from Sealants
D2203-01R23
ASTM|D2203-01R23|en-US
Standard Test Method for Staining from Sealants
Standard
D2203 Standard Test Method for Staining from Sealants>
new
BOS Vol. 04.07 Committee C24
$
64.00
In stock
Significance and Use
4.1 Staining of a building is an aesthetically undesirable occurrence. This test method evaluates the likelihood of a sealant causing an early stain on a porous substrate, when the stain is caused by gross exudation from the sealant. This test method does not predict staining caused by other factors.
4.2 See also Test Method C510.
Scope
1.1 This test method covers a laboratory procedure for determining whether a sample of sealant will cause staining of the substrate when in the contact with masonry, concrete, or stone (marble, limestone, sandstone, granite, etc.).
1.2 The values stated in SI (metric) units are to be regarded as the standard. The values given in parentheses are provided for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 1: Currently there is no ISO standard similar to this test method.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.