Standard
Active
Last Updated: Dec 14, 2020
Track Document
ASTM D2196-20
Standard Test Methods for Rheological Properties of Non-Newtonian Materials by Rotational Viscometer
Standard Test Methods for Rheological Properties of Non-Newtonian Materials by Rotational Viscometer
D2196-20
ASTM|D2196-20|en-US
Standard Test Methods for Rheological Properties of Non-Newtonian Materials by Rotational Viscometer
Standard
D2196 Standard Test Methods for Rheological Properties of Non-Newtonian Materials by Rotational Viscometer>
new
BOS Vol. 06.01 Committee D01
$
72.00
In stock
Significance and Use
3.1 Test Method A is used for determining the apparent viscosity at a given rotational speed, although viscosities at two or more speeds give better characterization of a non-Newtonian material than does a single viscosity measurement.
3.2 With Test Methods B and C, the extent of shear thinning is indicated by the drop in viscosity with increasing rotational speed. The degree of thixotropy is indicated by comparison of viscosities at increasing and decreasing rotational speeds (Test Method B), viscosity recovery (Test Method B), or viscosities before and after high shear (combination of Test Methods B and C). The high-shear treatment in Test Method C approximates shearing during paint application. The viscosity behavior measured after high shear is indicative of the characteristics of the paint soon after application.
Scope
1.1 These test methods cover the determination of the apparent viscosity and the shear thinning and thixotropic properties of non-Newtonian materials in the shear rate range from 0.1 s−1 to 50 s−1 using a rotational viscometer operating in a fluid contained in a 600 mL low form Griffin beaker.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.