Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM D1754-97(2002)
Standard Test Method for Effect of Heat and Air on Asphaltic Materials (Thin-Film Oven Test)
Standard Test Method for Effect of Heat and Air on Asphaltic Materials (Thin-Film Oven Test)
D1754-97R02
ASTM|D1754-97R02|en-US
Standard Test Method for Effect of Heat and Air on Asphaltic Materials (Thin-Film Oven Test)
Standard
D1754 Standard Test Method for Effect of Heat and Air on Asphaltic Materials (Thin-Film Oven Test)>
new
BOS Vol. 04.03 Committee D04
$
86.00
In stock
Significance and Use
This method indicates approximate change in properties of asphalt during conventional hot-mixing at about 150°C (302°F) as indicated by viscosity, penetration, or ductility measurements. It yields a residue which approximates the asphalt condition as incorporated in the pavement. If the mixing temperature differs appreciably from the 150°C (302°F) level, more or less effect on properties will occur.
Scope
1.1 This test method covers the determination of the effect of heat and air on a film of semisolid asphaltic materials. The effects of this treatment are determined from measurements of selected asphalt properties before and after the test.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.