Standard
Active
Last Updated: Apr 28, 2023
Track Document
ASTM D1514-23
Standard Test Method for Carbon Black—Sieve Residue
Standard Test Method for Carbon Black—Sieve Residue
D1514-23
ASTM|D1514-23|en-US
Standard Test Method for Carbon Black—Sieve Residue
Standard
D1514 Standard Test Method for Carbon Black—Sieve Residue>
new
BOS Vol. 09.01 Committee D24
$
64.00
In stock
ASTM International
Significance and Use
4.1 The quantity of sieve residue of carbon black is important in some molded or extruded products as it may relate to the surface appearance of those products. The maximum residue in each application is normally determined and agreed to between the user and the producer.
Scope
1.1 This test method covers the determination of the water wash sieve residue in regular untreated carbon blacks. It may not be applicable to oil-treated carbon blacks because the oil would prevent proper wetting of the black by water.
1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 6.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.