Standard
Active
Last Updated: Feb 21, 2020
Track Document
ASTM D991-89(2020)
Standard Test Method for Rubber Property—Volume Resistivity Of Electrically Conductive and Antistatic Products
Standard Test Method for Rubber Property—Volume Resistivity Of Electrically Conductive and Antistatic Products
D0991-89R20
ASTM|D0991-89R20|en-US
Standard Test Method for Rubber Property—Volume Resistivity Of Electrically Conductive and Antistatic Products
Standard
D991 Standard Test Method for Rubber Property—Volume Resistivity Of Electrically Conductive and Antistatic Products>
new
BOS Vol. 09.01 Committee D11
$
72.00
In stock
Significance and Use
4.1 The electrical behavior of rubber products used in particular applications is important for a variety of reasons such as safety, static changes, current transmission, etc. This test method is useful in predicting the behavior of such rubber products.
Scope
1.1 This test method covers the determination of volume resistivity of rubbers used in electrically conductive and antistatic products.
1.2 This test method assumes that the surface conductivity is negligible compared with the conductivity through the specimen.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.