Standard
Active
Last Updated: Mar 19, 2021
Track Document
ASTM D623-07(2019)e1
Standard Test Methods for Rubber Property—Heat Generation and Flexing Fatigue In Compression
Standard Test Methods for Rubber Property—Heat Generation and Flexing Fatigue In Compression
D0623-07R19E01
ASTM|D0623-07R19E01|en-US
Standard Test Methods for Rubber Property—Heat Generation and Flexing Fatigue In Compression
Standard
D623 Standard Test Methods for Rubber Property—Heat Generation and Flexing Fatigue In Compression>
new
BOS Vol. 09.01 Committee D11
$
86.00
In stock
ASTM International
Significance and Use
4.1 Because of wide variations in service conditions, no correlation between these accelerated tests and service performance is given or implied. However, the test methods yield data that can be used to estimate relative service quality of different compounds. They are often applicable to research and development studies.
Scope
1.1 These test methods may be used to compare the fatigue characteristics and rate of heat generation of different rubber vulcanizates when they are subjected to dynamic compressive strains.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.