Standard
Active
Last Updated: Mar 08, 2023
Track Document
ASTM D516-22
Standard Test Method for Sulfate Ion in Water
Standard Test Method for Sulfate Ion in Water
D0516-22
ASTM|D0516-22|en-US
Standard Test Method for Sulfate Ion in Water
Standard
D516 Standard Test Method for Sulfate Ion in Water>
new
BOS Vol. 11.01 Committee D19
$
72.00
In stock
Significance and Use
5.1 The determination of sulfate is important because it has been reported that when this ion is present in excess of about 250 mg/L in drinking water, it causes a cathartic action (especially in children) in the presence of sodium and magnesium, and gives a bad taste to the water.
5.2 Test Method D4327 (“Test Method of Anions in Water by Suppressed Ion Chromatography”) may be used.
Scope
1.1 This turbidimetric test method covers the determination of sulfate in water in the range from 5 mg/L to 40 mg/L of sulfate ion (SO4−−).
1.2 This test method was used successfully with drinking, ground, and surface waters. It is the user's responsibility to ensure the validity of this test method for waters of untested matrices.
1.3 Former gravimetric and volumetric test methods have been discontinued. Refer to Appendix X1 for historical information.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.