Standard
Historical
Last Updated: Sep 25, 2025
Track Document
ASTM D413-98(2017)
Standard Test Methods for Rubber Property—Adhesion to Flexible Substrate
Standard Test Methods for Rubber Property—Adhesion to Flexible Substrate
D0413-98R17
ASTM|D0413-98R17|en-US
Standard Test Methods for Rubber Property—Adhesion to Flexible Substrate
Standard
D413 Standard Test Methods for Rubber Property—Adhesion to Flexible Substrate>
new
BOS Vol. 09.01 Committee D11
$
86.00
In stock
ASTM International
Significance and Use
4.1 These test methods are used to ensure the quality of a product by determining the force per unit width required to separate a rubber layer from a flexible substrate such as fabric, fibre, wire, or sheet metal. The acceptable value of adhesion measured will, of course, vary from product to product due to different rubber formulations, flexible substrates, and types of products. However, once a product is established, minimum values of separation force can be determined and agreed to by producer and consumer and both can monitor to assure maintenance of the agreed-upon minimum value.
Scope
1.1 These test methods cover the determination of the adhesion strength between plies of fabric bonded with rubber or the adhesion of the rubber layer in articles made from rubber attached to other material. They are applicable only when the adhered surfaces are approximately plane or uniformly circular as in belting, hose, tire carcasses, or rubber-covered sheet metal.
1.2 When the adhered surfaces contain sharp bends, angles, or other gross irregularities that cannot be avoided in preparing test specimens, special test methods must be employed for evaluating adhesion.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.