Standard
Historical
Last Updated: Mar 04, 2015
Track Document
ASTM D312-00(2006)
Standard Specification for Asphalt Used in Roofing
Standard Specification for Asphalt Used in Roofing
D0312-00R06
ASTM|D0312-00R06|en-US
Standard Specification for Asphalt Used in Roofing
Standard
D312 Standard Specification for Asphalt Used in Roofing>
new
BOS Vol. 04.04 Committee D08
$
77.00
In stock
Abstract
This specification covers four types of asphalt intended for use in built-up roof construction, construction of some modified bitumen systems, construction of bituminous vapor retarder systems, and for adhering insulation boards used in various types of roof systems. The asphalts shall be prepared from crude petroleum. Asphalts shall be classified as: Type I; Type II; Type III; and Type IV. Asphalts of each type shall conform to the physical properties prescribed. Tests shall be performed to determine the properties of the material in accordance with the following methods: sampling; softening point; flash point; penetration; ductility; and solubility.
Scope
1.1 This specification covers four types of asphalt intended for use in built-up roof construction, construction of some modified bitumen systems, construction of bituminous vapor retarder systems, and for adhering insulation boards used in various types of roof systems. The specification is intended for general classification purposes only, and does not imply restrictions on the slope at which an asphalt must be used.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.