Standard
Historical
Last Updated: Aug 16, 2017
Track Document
ASTM D228-04
Standard Test Methods for Sampling, Testing, and Analysis of Asphalt Roll Roofing, Cap Sheets, and Shingles Used in Roofing and Waterproofing
Standard Test Methods for Sampling, Testing, and Analysis of Asphalt Roll Roofing, Cap Sheets, and Shingles Used in Roofing and Waterproofing
D0228-04
ASTM|D0228-04|en-US
Standard Test Methods for Sampling, Testing, and Analysis of Asphalt Roll Roofing, Cap Sheets, and Shingles Used in Roofing and Waterproofing
Standard
D228 Standard Test Methods for Sampling, Testing, and Analysis of Asphalt Roll Roofing, Cap Sheets, and Shingles Used in Roofing and Waterproofing>
new
BOS Vol. 04.04 Committee D08
$
96.00
In stock
Scope
1.1 These test methods include procedures for sampling, examination, physical testing, and analyses of asphalt-containing materials used in roofing and waterproofing. These materials include but are not limited to roll roofing, cap sheets, and shingles. Any of these materials are allowed to be partially or fully coated, surfaced, or laminated, or combination thereof.
1.2 The test methods and procedures in this standard appear in the following order:
| Section | Content |
| 5 | Types of Roofing |
| 6 | Sampling |
| 7 | Mass and Area Determination |
| 8 | Selection of Representative Specimens |
| 9 | Moisture |
| 10 | Pliability |
| 11 | Mass Loss and Behavior on Heating |
| 12 | Tear Strength |
| 13 | Fastener Pull-Through Resistance |
| 14 | Preparation and Selection of Small Test Specimens for Analyses |
| 15 | Analysis of Glass Felt Products |
| 16 | Analysis of Roofing Products with Organic or Asbestos Felts |
| 17 | Ash of Desaturated Felt |
| 18 | Calculation |
| 19 | Adjusting Back Coating Fine Mineral Matter and Back Surfacing |
| 20 | Report |
| 21 | Precision and Bias |
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.