Standard
Active
Last Updated: Dec 09, 2019
Track Document
ASTM D197-19
Standard Test Method for Sampling and Fineness Test of Pulverized Coal
Standard Test Method for Sampling and Fineness Test of Pulverized Coal
D0197-19
ASTM|D0197-19|en-US
Standard Test Method for Sampling and Fineness Test of Pulverized Coal
Standard
D197 Standard Test Method for Sampling and Fineness Test of Pulverized Coal>
new
BOS Vol. 05.06 Committee D05
$
72.00
In stock
Significance and Use
3.1 This test method provides a means for assisting in the evaluation of pulverizers and pulverizer systems in terms of fineness specifications. It may also be used to confirm the influence of coal fineness on combustion performance and to evaluate carbon loss. By consent among interested parties, it may be used for evaluation of coal fineness in preparation, pneumatic transfer systems, etc.
Scope
1.1 This test method covers the determination of the fineness by sieve analysis of coal sampled from a dry pulverizing operation. It is not applicable to products of wet milling or to fines that have clustered into an agglomerated mass.
1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.