Standard
Active
Last Updated: Oct 25, 2024
Track Document
ASTM D95-23e1
Standard Test Method for Water in Petroleum Products and Bituminous Materials by Distillation
Standard Test Method for Water in Petroleum Products and Bituminous Materials by Distillation
D0095-23E01
ASTM|D0095-23E01|en-US
Standard Test Method for Water in Petroleum Products and Bituminous Materials by Distillation
Standard
D95 Standard Test Method for Water in Petroleum Products and Bituminous Materials by Distillation>
new
BOS Vol. 05.01 Committee D02
$
72.00
In stock
ASTM International
Significance and Use
5.1 A knowledge of the water content of petroleum products is important in the refining, purchase, sale, and transfer of products.
5.2 The amount of water as determined by this test method (to the nearest 0.05 % or 0.1 % by volume, depending on the trap size used) may be used to correct the volume involved in the custody transfer of petroleum products and bituminous materials.
5.3 The allowable amount of water may be specified in contracts.
Scope
1.1 This test method covers the determination of water in the range from 0 % to 25 % by volume in petroleum products, tars, and other bituminous materials by the distillation method.
Note 1: Volatile water-soluble material, if present, may be measured as water.
1.2 The specific products considered during the development of this test method are listed in Table 1. For bituminous emulsions refer to Test Method D244. For crude oils, refer to Test Method D4006 (API MPMS Chapter 10.2).
Note 2: With some types of oil, satisfactory results may be obtained from Test Method D1796 (API MPMS Chapter 10.6).
1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 6.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.