Standard
Active
Last Updated: May 16, 2024
Track Document
ASTM C1737-24
Standard Guide for Evaluating Temperature Effects to Aerosol Foam Sealant During and After Dispensing
Standard Guide for Evaluating Temperature Effects to Aerosol Foam Sealant During and After Dispensing
C1737-24
ASTM|C1737-24|en-US
Standard Guide for Evaluating Temperature Effects to Aerosol Foam Sealant During and After Dispensing
Standard
C1737 Standard Guide for Evaluating Temperature Effects to Aerosol Foam Sealant During and After Dispensing>
new
BOS Vol. 04.07 Committee C24
$
64.00
In stock
ASTM International
Significance and Use
5.1 This guide is not intended to measure the precise temperature range for dispensing and curing product under all the possible substrate and environmental factors, but to provide a basis for benchmarking a foam sealant product under specific laboratory conditions.
5.1.1 The data, observations, and rankings reported for tests identified in this guide are subjective to the individuals conducting the tests and internal laboratory standards. Therefore, direct comparison of results reported for testing conducted by different laboratories is not recommended.
5.2 The product user is encouraged to evaluate each application and determine suitability for actual use.
Scope
1.1 This guide covers the general effects of temperature from the aerosol foam sealant (either polyurethane or latex types) under the use temperatures.
1.2 The guide is intended to estimate the observed product dispensing characteristics and foam quality of aerosol foam dispensed or cured, or both, at specific temperatures and standard conditions.
1.3 Such foam sealants are primarily intended to reduce air movement in and out of building enclosures.
1.4 Currently two main foam sealant types are applicable to this standard: single component polyurethane and latex.
1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.6 There are no other known test methods specific for measuring the product temperature range for aerosol foam sealant.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.