Standard
Active
Last Updated: Nov 26, 2024
Track Document
ASTM C1643-14(2024)
Standard Test Method to Measuring the Post Dispensing Volumetric Expansion of Aerosol Foam Sealants
Standard Test Method to Measuring the Post Dispensing Volumetric Expansion of Aerosol Foam Sealants
C1643-14R24
ASTM|C1643-14R24|en-US
Standard Test Method to Measuring the Post Dispensing Volumetric Expansion of Aerosol Foam Sealants
Standard
C1643 Standard Test Method to Measuring the Post Dispensing Volumetric Expansion of Aerosol Foam Sealants>
new
BOS Vol. 04.07 Committee C24
$
64.00
In stock
ASTM International
Significance and Use
5.1 Post dispensing volumetric expansion factor F indicates the ratio of the fully cured foam sealant volume and the initially dispensed foam sealant volume. For example, if the expansion factor F were 2, the fully cured foam would double its initial volume; therefore, one should fill 50 % of the cavity uniformly to anticipate the full coverage upon curing.
5.2 Post dispensing volumetric expansion factor F does not predict the performance capability of the foam sealants of the suitability for the intended applications.
5.3 This test method is intended to lend guidance in product selection as related to the post dispensing expansion characteristics of the aerosol foam sealants.
5.4 This test method recognizes that the results are reflective of controlled laboratory conditions. Post dispensing expansion in field applications may vary according to temperature, humidity, and surfaces that the aerosol foam sealants are in contact with.
Scope
1.1 This test method measures the volumetric expansion of aerosol foam sealants after dispensing.
1.2 This test method provides a means for estimating the quantity of initial material required to dispense in order to fill a cavity.
1.3 Aerosol foam sealants are used for a variety of applications intended to reduce airflow through the building envelope.
1.4 This test method applies to two types of single component aerosol foam sealants: polyurethane and latex.
1.5 There are no other known standard test methods to measure aerosol foam sealants post dispensing expansion.
1.6 Values are reported in SI units only. Certain apparatus and supply items are referenced in inch-pound units for purchasing purposes.
1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.