Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM C1354-96(2004)
Standard Test Method for Strength of Individual Stone Anchorages in Dimension Stone
Standard Test Method for Strength of Individual Stone Anchorages in Dimension Stone
C1354-96R04
ASTM|C1354-96R04|en-US
Standard Test Method for Strength of Individual Stone Anchorages in Dimension Stone
Standard
C1354 Standard Test Method for Strength of Individual Stone Anchorages in Dimension Stone>
new
BOS Vol. 04.07 Committee C18
$
86.00
In stock
Significance and Use
This test method is intended to provide information from which applicable design data can be determined for a given anchor used to support a dimension stone panel. The strength of a limited length of anchor may be related to a longer length of support when the flexibility of the support is properly considered by the designer. Refer to Guide C 1242
Scope
1.1 This test method provides procedures for determining the ultimate strength of an assembly consisting of stone with mechanical anchor (anchorage). Load is applied, separately, perpendicular to the surface of the panel and parallel to the surface of the panel. This test is intended to represent the interaction of the anchor with the stone panel. However, influence of the backup structure on the strength of the assemblies is not included.
1.2 This method is applicable to stone panels supported by mechanical anchors.
1.3 The values stated in SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.