Standard
Active
Last Updated: Nov 16, 2018
Track Document
ASTM C1254-18
Standard Test Method for Determination of Uranium in Mineral Acids by X-Ray Fluorescence
Standard Test Method for Determination of Uranium in Mineral Acids by X-Ray Fluorescence
C1254-18
ASTM|C1254-18|en-US
Standard Test Method for Determination of Uranium in Mineral Acids by X-Ray Fluorescence
Standard
C1254 Standard Test Method for Determination of Uranium in Mineral Acids by X-Ray Fluorescence>
new
BOS Vol. 12.01 Committee C26
$
72.00
In stock
Significance and Use
5.1 This test method is applicable to aqueous solutions of uranium containing 0.05 to 20 g uranium per litre of solution presented to the spectrometer.
5.2 Either wavelength-dispersive or energy-dispersive X-ray fluorescence systems may be used provided the software accompanying the system is able to accommodate the use of internal standards.
Scope
1.1 This test method covers the steps necessary for the preparation and analysis by X-ray fluorescence (XRF) of mineral acid solutions containing uranium.
1.2 This test method is valid for those solutions containing 0.05 to 20 g uranium/L as presented to the spectrometer. Higher concentrations may be covered by appropriate dilutions.
1.3 The values stated in SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 9 and Note 1.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.