Standard
Historical
Last Updated: Jun 06, 2023
Track Document
ASTM C1184-18e1
Standard Specification for Structural Silicone Sealants
Standard Specification for Structural Silicone Sealants
C1184-18E01
ASTM|C1184-18E01|en-US
Standard Specification for Structural Silicone Sealants
Standard
C1184 Standard Specification for Structural Silicone Sealants>
new
BOS Vol. 04.07 Committee C24
$
77.00
In stock
ASTM International
Abstract
This specification describes the properties of cold liquid applied, single-component or multicomponent, chemically curing elastomeric structural silicone sealants herein referred to as the sealant. These sealants are intended to structurally adhere components of structural sealant glazing systems. Sealants shall be classified as to types and uses: Type S; Type M; Use G; and Use O. The physical, mechanical, and performance properties of the sealant shall conform to the requirements described. The following test methods shall be performed: rheological properties; extrudability; hardness; heat aging; tack-free time; tensile adhesion; and shelf life.
Scope
1.1 This specification describes the properties of cold liquid applied, single-component or multicomponent, chemically curing elastomeric structural silicone sealants herein referred to as the sealant. These sealants are intended to structurally adhere components of structural sealant glazing systems.
1.2 Only those properties for which there are industry-agreed-upon minimum acceptable requirements, as determined by available ASTM test methods, are described in this specification. Additional properties may be added as ASTM test methods for those properties become available.
1.3 The values stated in metric (SI) units are to be regarded as the standard. The values in parentheses are for information only.
1.4 Committee C24, with jurisdiction over this specification, is aware of two comparable standards by other organizations: ETAG No. 002 and the Chinese national standard GB16776.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.