Standard
Historical
Last Updated: Jan 09, 2013
Track Document
ASTM C1138M-05(2010)e1
Standard Test Method for Abrasion Resistance of Concrete (Underwater Method)
Standard Test Method for Abrasion Resistance of Concrete (Underwater Method)
C1138M-05R10E01
ASTM|C1138M-05R10E01|en-US
Standard Test Method for Abrasion Resistance of Concrete (Underwater Method)
Standard
C1138M Standard Test Method for Abrasion Resistance of Concrete (Underwater Method)>
new
BOS Vol. 04.02 Committee C09
$
77.00
In stock
Significance and Use
This test method is intended to qualitatively simulate the behavior of swirling water containing suspended and transported solid objects that produce abrasion of concrete and cause potholes and related effects.
This test method should provide a relative evaluation of the resistance of concrete to such action.
The results are expected to be useful in selection of materials, mixtures, and construction practices for use where such action is to be expected.
The test method is not intended to provide a quantitative measurement of the length of service that may be expected from a specific concrete.
Scope
1.1 This test method covers a procedure for determining the relative resistance of concrete (including concrete overlays and impregnated concrete) to abrasion under water (see Note 1). This procedure simulates the abrasive action of waterborne particles (silt, sand, gravel, and other solids).
Note 1—Other procedures are available for measuring abrasion resistance of concrete surfaces not under water. These include Test Methods C418, C779/C779M, and C944.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (Warning