Standard
Historical
Last Updated: Oct 03, 2012
Track Document
ASTM C1073-97a(2003)
Standard Test Method for Hydraulic Activity of Ground Slag by Reaction with Alkali
Standard Test Method for Hydraulic Activity of Ground Slag by Reaction with Alkali
C1073-97AR03
ASTM|C1073-97AR03|en-US
Standard Test Method for Hydraulic Activity of Ground Slag by Reaction with Alkali
Standard
C1073 Standard Test Method for Hydraulic Activity of Ground Slag by Reaction with Alkali>
new
BOS Vol. 04.02 Committee C09
$
77.00
In stock
Significance and Use
This test method can be used as a quality-control test for slag production from a single source after adequate correlation with tests stipulated in Specification C 989
This test method may be used as an evaluation technique for slag, when an appropriate correlation with various finenesses of slags from a specific source ground in a specific laboratory mill has been previously developed.
The hydraulic activity as measured by this test method on ground-slag samples can provide guidance to a manufacturer as to fineness level required to maintain a certain level of hydraulic activity.
While this test method is intended primarily as a quality control test, some studies have shown that the test method is capable of evaluating the hydraulic activity of slags from different sources.
Scope
1.1 This test method covers the rapid determination of hydraulic activity of ground-granulated iron blast-furnace slag. This test method measures the accelerated strength development of the slag by using sodium hydroxide solution as mixing water and curing at elevated temperature.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific warning statement is given in Section 6.
1.4 The text of this standard references notes and footnotes (excluding those in tables) shall not be considered as requirements of this standard.