Standard
Historical
Last Updated: Sep 24, 2014
Track Document
ASTM C916-85(2007)
Standard Specification for Adhesives for Duct Thermal Insulation
Standard Specification for Adhesives for Duct Thermal Insulation
C0916-85R07
ASTM|C0916-85R07|en-US
Standard Specification for Adhesives for Duct Thermal Insulation
Standard
C916 Standard Specification for Adhesives for Duct Thermal Insulation>
new
BOS Vol. 04.06 Committee C16
$
77.00
In stock
Abstract
This specification covers minimum material requirements, and safety precautions in application, for adhesives to bond thermal insulation duct liner on the interior surfaces of sheet metal air conditioning ducts; and for coating exposed edges and joints of duct liner thermal insulation to minimize erosion of insulation fibers by air movement. Adhesives shall be classified as follows: Type I; Type II; Type III; and Type IV. The following test methods shall be performed: bonding strength; bond retention after heat aging; flame spread and smoke developed; edge-burning test; storage stability; and precision and bias.
Scope
1.1 This specification covers minimum material requirements, and safety precautions in application, for adhesives to bond thermal insulation duct liner on the interior surfaces of sheet metal air conditioning ducts; and for coating exposed edges and joints of duct liner thermal insulation to minimize erosion of insulation fibers by air movement.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Sections 7 and 9.