Standard
Historical
Last Updated: Apr 30, 2025
Track Document
ASTM C796/C796M-19
Standard Test Method for Foaming Agents for Use in Producing Cellular Concrete Using Preformed Foam
Standard Test Method for Foaming Agents for Use in Producing Cellular Concrete Using Preformed Foam
C0796_C0796M-19
ASTM|C0796_C0796M-19|en-US
Standard Test Method for Foaming Agents for Use in Producing Cellular Concrete Using Preformed Foam
Standard
C796/C796M Standard Test Method for Foaming Agents for Use in Producing Cellular Concrete Using Preformed Foam>
new
BOS Vol. 04.02 Committee C09
$
86.00
In stock
ASTM International
Significance and Use
5.1 This test method is used to develop data for comparison or compliance with the requirements of Specification C869/C869M.
Scope
1.1 This test method furnishes a way of measuring, in the laboratory, the performance of a foaming chemical to be used in producing foam (air cells) for making cellular concrete.
1.2 This test method includes the following:
1.2.1 Manufacture of laboratory quantities of cellular concrete.
1.2.2 Determination of the air content of the freshly prepared cellular concrete and of the hardened concrete after handling in conventional machinery.
1.2.3 Determination of the following properties of the hardened concrete: compressive strength, tensile splitting strength, density, and water absorption. It may not be necessary to study all of the above properties in all cases, depending on the proposed use of the material.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.4 If the required results obtained from another standard are not reported in the same system of units as used by this standard, it is permitted to convert those results using the conversion factors found in the SI Quick Reference Guide.
1.5 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.