Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM C565-93(2005)
Standard Test Methods for Tension Testing of Carbon and Graphite Mechanical Materials
Standard Test Methods for Tension Testing of Carbon and Graphite Mechanical Materials
C0565-93R05
ASTM|C0565-93R05|en-US
Standard Test Methods for Tension Testing of Carbon and Graphite Mechanical Materials
Standard
C565 Standard Test Methods for Tension Testing of Carbon and Graphite Mechanical Materials>
new
BOS Vol. 05.05 Committee D02
$
77.00
In stock
Significance and Use
These test methods may be used for quality control testing of established grades of carbon and graphite materials, in the development of new grades, and for other purposes where relative strength levels are the primary quantities of interest. This test method may be applicable only if the ratio of specimen diameter to grain size, or flaw size, is greater than 5.
These test methods do not substitute for that described in Test Method C 749
Carbon and graphite materials exhibit significant physical property differences within parent materials. Exact sampling patterns and grain orientations must be specified in order to make meaningful tensile strength comparisons.
Scope
1.1 These test methods cover the apparatus, specimen, and procedures for the tension testing of carbon and graphite mechanical materials with a grain size smaller than 0.79 mm (1/32 in.).
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.