Standard
Active
Last Updated: May 27, 2022
Track Document
ASTM C367/C367M-22
Standard Test Methods for Strength Properties of Prefabricated Architectural Acoustical Tile or Lay-In Ceiling Panels
Standard Test Methods for Strength Properties of Prefabricated Architectural Acoustical Tile or Lay-In Ceiling Panels
C0367_C0367M-22
ASTM|C0367_C0367M-22|en-US
Standard Test Methods for Strength Properties of Prefabricated Architectural Acoustical Tile or Lay-In Ceiling Panels
Standard
C367/C367M Standard Test Methods for Strength Properties of Prefabricated Architectural Acoustical Tile or Lay-In Ceiling Panels>
new
BOS Vol. 04.06 Committee E33
$
72.00
In stock
Significance and Use
4.1 Knowledge of hardness is useful in the development and the quality control of acoustical tile and lay-in ceiling panels. Deviation from an established hardness range will assist in pointing out processing errors or defective raw materials, thereby aiding the maintenance of uniform product quality.
4.2 This property is also useful in comparing the relative abilities of materials to resist indentations on the panel surface caused by impacts.
4.3 Since the hardness varies with the thickness, only samples of the same thickness shall be directly compared.
Scope
1.1 These test methods cover the determination of the strength properties of prefabricated architectural acoustical tile or lay-in ceiling panels as follows:
| Tests | Sections |
| Hardness | 4 to 9 |
| Friability | 10 to 16 |
| Sag | 17 to 23 |
| Transverse strength | 24 to 30 |
1.2 Not all of the tests described in these test methods are necessary to evaluate any particular product for a specific use. In each instance, it is necessary to determine which properties are required.
1.3 These test methods specify procedures that are used in product development, manufacturing control, specification acceptance, and service evaluation.
1.4 Properties determined by these test methods reflect the performance of the materials under the specific conditions of the test, and do not necessarily indicate performance under conditions other than those specified herein.
1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems will result in non-conformance with the standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.