Standard
Historical
Last Updated: Aug 02, 2016
Track Document
ASTM C78/C78M-15b
Standard Test Method for Flexural Strength of Concrete (Using Simple Beam with Third-Point Loading)
Standard Test Method for Flexural Strength of Concrete (Using Simple Beam with Third-Point Loading)
C0078_C0078M-15B
ASTM|C0078_C0078M-15B|en-US
Standard Test Method for Flexural Strength of Concrete (Using Simple Beam with Third-Point Loading)
Standard
C78/C78M Standard Test Method for Flexural Strength of Concrete (Using Simple Beam with Third-Point Loading)>
new
BOS Vol. 04.02 Committee C09
$
77.00
In stock
Significance and Use
3.1 This test method is used to determine the flexural strength of specimens prepared and cured in accordance with Test Methods C42/C42M or Practices C31/C31M or C192/C192M. Results are calculated and reported as the modulus of rupture. For the same specimen size, the strength determined will vary if there are differences in specimen preparation, curing procedure, moisture condition at time of testing, and whether the beam was molded or sawed to size.
3.2 The measured modulus of rupture generally increases as the specimen size decreases3,4,5 and it has been shown that the variability of individual test results increases as the specimen size decreases.3,4
3.3 The results of this test method may be used to determine compliance with specifications or as a basis for mixture proportioning, evaluating uniformity of mixing, and checking placement operations by using sawed beams. It is used primarily in testing concrete for the construction of slabs and pavements.
Scope
1.1 This test method covers the determination of the flexural strength of concrete by the use of a simple beam with third-point loading.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.