Standard
Historical
Last Updated: Apr 18, 2022
Track Document
ASTM B684/B684M-16
Standard Specification for Platinum-Iridium Electrical Contact Materials
Standard Specification for Platinum-Iridium Electrical Contact Materials
B0684_B0684M-16
ASTM|B0684_B0684M-16|en-US
Standard Specification for Platinum-Iridium Electrical Contact Materials
Standard
B684/B684M Standard Specification for Platinum-Iridium Electrical Contact Materials>
new
BOS Vol. 02.04 Committee B02
$
77.00
In stock
Abstract
This specification covers two platinum-iridium alloys in the form of rod, wire, strip, and sheet material for electrical contacts. Raw materials shall be of such quality and purity that the finished product (produced by cold working, annealing, turning, grinding, or pickling as required) will have the properties and characteristics prescribed in this specification. The alloys shall meet the requirements of chemical composition specified for platinum, iridium, total impurities, total platinum group (palladium, rhodium, osmium, ruthenium, and gold), total other impurities (including lead, antimony, bismuth, tin, arsenic, cadmium, zinc, and iron) and other elements. Ultimate tensile strength, elongation, microhardness (Knoop or Vickers), hardness (Rockwell or Rockwell Superficial), or a combination of these mechanical properties may be specified as criterion for temper designation. Annealed and work hardened wire and strip shall conform to the mechanical requirements prescribed for ultimate tensile strength, elongation, and microhardness. Knoop hardness test, tension test, and chemical analysis using spectrochemical or wet analysis method shall be performed.
Scope
1.1 This specification covers an 85 % platinum—15 % iridium alloy, and a 90 % platinum—10 % iridium alloy, in the form of rod, wire, strip, and sheet material for electrical contacts.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.