Standard
Active
Last Updated: May 16, 2023
Track Document
ASTM B647-23
Standard Test Method for Indentation Hardness of Aluminum Alloys by Means of a Webster Hardness Gage
Standard Test Method for Indentation Hardness of Aluminum Alloys by Means of a Webster Hardness Gage
B0647-23
ASTM|B0647-23|en-US
Standard Test Method for Indentation Hardness of Aluminum Alloys by Means of a Webster Hardness Gage
Standard
B647 Standard Test Method for Indentation Hardness of Aluminum Alloys by Means of a Webster Hardness Gage>
new
BOS Vol. 02.02 Committee B07
$
64.00
In stock
ASTM International
Significance and Use
4.1 The Webster hardness gage is portable and therefore useful for in situ determination of the hardness of fabricated parts and individual test specimens for production control purposes. It is not as sensitive as Rockwell or Brinell hardness machines; see 10.2.
4.2 This test method should be used only as cited in applicable material specifications.
Scope
1.1 This test method covers the determination of indentation hardness of aluminum alloys with a Webster hardness gage, Model B.
1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.
Note 1: Two other models, A and B-75, are in use, but are not covered in this test method. Model A does not provide numerical values of hardness and Model B-75 covers only a part of the range of interest for aluminum alloys.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.