Standard
Historical
Last Updated: Dec 16, 2013
Track Document
ASTM B482-85(2008)
Standard Practice for Preparation of Tungsten and Tungsten Alloys for Electroplating
Standard Practice for Preparation of Tungsten and Tungsten Alloys for Electroplating
B0482-85R08
ASTM|B0482-85R08|en-US
Standard Practice for Preparation of Tungsten and Tungsten Alloys for Electroplating
Standard
B482 Standard Practice for Preparation of Tungsten and Tungsten Alloys for Electroplating>
new
BOS Vol. 02.05 Committee B08
$
77.00
In stock
Abstract
This practice contains two recommendations based on several reported practices for the process selection in electroplating on tungsten and tungsten alloys. Surfaces should be cleaned either by descaling, solvent cleaning, or alkaline soak cleaning before electroplating. Evaluating which of the suggested processes to use is dependent on the application of the produced coating.
Scope
1.1 This practice makes recommendations of several reported practices for electroplating on tungsten and its alloys along with comments as a guide in the selection of a processing method for a given application. Because data on methods and results of evaluation with electroplated coatings on tungsten are limited, a recommendation of one method over another cannot be made.
1.2 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.