Standard
Historical
Last Updated: Jun 07, 2022
Track Document
ASTM B467-14
Standard Specification for Welded Copper-Nickel Pipe
Standard Specification for Welded Copper-Nickel Pipe
B0467-14
ASTM|B0467-14|en-US
Standard Specification for Welded Copper-Nickel Pipe
Standard
B467 Standard Specification for Welded Copper-Nickel Pipe>
new
BOS Vol. 02.01 Committee B05
$
72.00
In stock
Significance and Use
18.1 For purposes of determining compliance with the specified limits for requirements of the properties listed in the following table, and observed value or a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29.
| Property | Rounded Unit for Observed or Calculated Value |
|
| |
| Chemical composition | nearest unit in the last right-hand place of figures of the specified limit |
| Tensile strength | nearest ksi (nearest MPa up to 10 ksi, incl, nearest 5 MPa over 10 ksi) |
| Elongation | nearest 1 % |
Abstract
This specification covers welded copper-nickel alloy pipes produced from Copper Alloy UNS Nos. C70600 and C71500 for general engineering applications. Pipes may be produced in any one of the following tempers: as-welded from annealed sheets, strips, or plates (WM50); as-welded from cold-worked sheets, strips, or plates (WM00, WM01, WM02, and so forth); welded and annealed (WO50); welded, light cold drawn (WR00) or hard cold drawn (WR04), and stress relieved; or fully finished as annealed, light drawn (WH00) or hard drawn (WH04), and stress relieved. Products shall be sampled and prepared, then tested accordingly to examine their conformance to dimensional (outside diameter, specific and stock lengths, wall thickness, squareness of cut, and roundness), mechanical (tensile and yield strengths, and elongation), and chemical composition requirements. Specimens shall also undergo nondestructive tests such as radiographic examination, eddy-current test, and hydrostatic test.
Scope
1.1 This specification establishes the requirements for welded copper-nickel alloy pipe for general engineering purposes. The following alloys are covered:2
| Copper Alloy | Type of Metal |
|
|
|
| C70600 | 90-10 copper-nickel |
| C70620 | 90-10 copper-nickel |
|
| (Modified for Welding) |
| C71500 | 70-30 copper-nickel |
| C71520 | 70-30 copper-nickel |
|
| (Modified for Welding) |
1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.