Standard
Active
Last Updated: May 30, 2018
Track Document
ASTM B392-18
Standard Specification for Niobium and Niobium Alloy Bar, Rod, and Wire
Standard Specification for Niobium and Niobium Alloy Bar, Rod, and Wire
B0392-18
ASTM|B0392-18|en-US
Standard Specification for Niobium and Niobium Alloy Bar, Rod, and Wire
Standard
B392 Standard Specification for Niobium and Niobium Alloy Bar, Rod, and Wire>
new
BOS Vol. 02.04 Committee B10
$
64.00
In stock
Significance and Use
13.1 For the purposes of determining compliance with the specified limits for requirements of the properties listed in this specification, an observed value or a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29.
Abstract
This specification covers four grades of wrought niobium and niobium alloy bar, rod, and wire as R04200-Type 1, reactor grade unalloyed niobium; R04210-Type 2, commercial grade unalloyed niobium; R04251-Type 3, reactor grade niobium alloy containing 1 % zirconium; and R04261-Type 4, commercial grade niobium alloy containing 1 % zirconium. The chemical; and mechanical properties requirements, such as Brinell hardness, tensile strength, yield strength, and elongations; as well as the temper designations are detailed.
Scope
1.1 This specification covers four grades of wrought niobium and niobium alloy bar, rod, and wire as follows:
1.1.1 R04200-Type 1—Reactor grade unalloyed niobium,
1.1.2 R04210-Type 2—Commercial grade unalloyed niobium,
1.1.3 R04251-Type 3—Reactor grade niobium alloy containing 1 % zirconium, and
1.1.4 R04261-Type 4—Commercial grade niobium alloy containing 1 % zirconium.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.