Standard
Historical
Last Updated: Dec 18, 2013
Track Document
ASTM B281-88(2008)
Standard Practice for Preparation of Copper and Copper-Base Alloys for Electroplating and Conversion Coatings
Standard Practice for Preparation of Copper and Copper-Base Alloys for Electroplating and Conversion Coatings
B0281-88R08
ASTM|B0281-88R08|en-US
Standard Practice for Preparation of Copper and Copper-Base Alloys for Electroplating and Conversion Coatings
Standard
B281 Standard Practice for Preparation of Copper and Copper-Base Alloys for Electroplating and Conversion Coatings>
new
BOS Vol. 02.05 Committee B08
$
77.00
In stock
Significance and Use
The proper preparation of copper and copper alloy surfaces for electroplating, conversion coating, or autocatalytic plating is often critical to the performance of the coatings.
This practice outlines procedures required to produce satisfactory coatings on surfaces of copper and copper alloy surfaces.
Scope
1.1 This practice is intended to serve as a guide for the proper preparation of copper and its alloys for electroplating and conversion coating. This practice is also suitable for use before autocatalytic plating. Only alloys containing at least 50 mass % copper are considered within the scope of this practice.
1.2 The wide variety of methods of mechanical finishing are not considered strictly as preparation for electroplating or conversion coating and consequently are described only briefly.
1.3 Details of electroplating and subsequent treatments for applying conversion coatings are not within the scope of this practice.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see 6.5.2.