Standard
Active
Last Updated: Jul 07, 2021
Track Document
ASTM B99/B99M-15(2021)
Standard Specification for Copper-Silicon Alloy Wire for General Applications
Standard Specification for Copper-Silicon Alloy Wire for General Applications
B0099_B0099M-15R21
ASTM|B0099_B0099M-15R21|en-US
Standard Specification for Copper-Silicon Alloy Wire for General Applications
Standard
B99/B99M Standard Specification for Copper-Silicon Alloy Wire for General Applications>
new
BOS Vol. 02.01 Committee B05
$
64.00
In stock
Abstract
This specification establishes the requirements for round, rectangular, and square copper-silicon alloy wires with Copper Alloy UNS Nos. C65100 and 65500 for general applications other than electrical transmission cables. Tempers available under this specification are O61 (annealed), H00 (1/8 hard), H01 (¼ hard), H02 (½ hard), H04 (hard), and H08 (spring). Materials shall be tested and adhere to dimensional (mass, diameter, thickness, and width), mechanical (tensile and bending strength, and elongation), chemical composition, and grain size requirements.
Scope
1.1 This specification establishes the requirements for round, rectangular, and square wire for general applications other than for electrical transmission cable. The alloys involved are UNS Nos. C65100 and C65500.
1.2 Units—The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.