Standard
Active
Last Updated: Oct 11, 2023
Track Document
ASTM B36/B36M-23
Standard Specification for Brass Plate, Sheet, Strip, And Rolled Bar
Standard Specification for Brass Plate, Sheet, Strip, And Rolled Bar
B0036_B0036M-23
ASTM|B0036_B0036M-23|en-US
Standard Specification for Brass Plate, Sheet, Strip, And Rolled Bar
Standard
B36/B36M Standard Specification for Brass Plate, Sheet, Strip, And Rolled Bar>
new
BOS Vol. 02.01 Committee B05
$
72.00
In stock
ASTM International
Abstract
This specification establishes the requirements brass plates, sheets, strips, and rolled bars made from UNS C21000, C22000, C22600, C23000, C24000, C26000, C26800, C27200, or C28000. Plates are generally available only in the hot-rolled temper. The standard tempers of as hot rolled, rolled, annealed, and annealed-to-temper materials are detailed in this specification as well as in other specifications listed herein. This specification also contains information on the required tensile strengths, Rockwell hardness and grain sizes of the materials. The Rockwell hardness test can be used to test for general conformity to the specification requirements for temper, tensile strength and grain size.
Scope
1.1 This specification establishes the requirements for brass (copper-zinc alloy) plate, sheet, strip, and rolled bar of the following alloys:
| Copper Alloy | Type of Metal |
|
|
|
| C21000 | Gilding |
| C22000 | Commerical Bronze |
| C22600 | Jewerly Bronze |
| C23000 | Red Brass |
| C24000 | Low Brass |
| C26000 | Cartridge Brass |
| C26800 | Yellow Brass |
| C27200 | … |
| C28000 | Muntz Metal |
1.2 Units—The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 The following safety hazard caveat pertains only to the test method(s) described in this specification.
1.3.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.