Standard
Historical
Last Updated: Nov 19, 2012
Track Document
ASTM A1067/A1067M-12
Standard Specification for Test Coupons for Steel Castings
Standard Specification for Test Coupons for Steel Castings
A1067_A1067M-12
ASTM|A1067_A1067M-12|en-US
Standard Specification for Test Coupons for Steel Castings
Standard
A1067/A1067M Standard Specification for Test Coupons for Steel Castings>
new
BOS Vol. 01.02 Committee A01
$
86.00
In stock
Abstract
This specification defines the geometries of several separately-cast and integrally-cast test coupons for use as specified in the applicable casting product or common requirements standard. Procedures for molding, casting, heat treating, machining, or testing are not covered in the standard, and are instead addressed as needed and appropriate by the applicable product or common requirements standard. The applicable casting product standard or common requirements standard or both provide information regarding the number of coupons, molding materials to be used, heat treatment concerns, and other processing issues. The primary function of the test coupon is to provide sound specimens usable for the determination of mechanical, physical, corrosion, or other properties of the metal used to produce the castings. If the test results conform to the stated requirements, then the test coupon may be considered to have functioned acceptably.
Scope
1.1 This specification defines the geometries of several separately-cast and integrally-cast test coupons for use as specified in the applicable casting product or common requirements standard. This standard does not address procedures for molding, casting, heat treating, machining, or testing; these items are addressed as needed and appropriate by the applicable product or common requirements standard.
1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.